Search
Close this search box.
EN

Quill Travel

Definition of Quill Travel

Quill travel is the maximum distance the quill, and the spindle running inside it, can move down from its fully raised position. It is also called quill stroke or spindle stroke. The quill is a hardened, ground sleeve that slides in a bore in the head. A rack cut along its side meshes with a pinion turned by the three-spoke feed lever or the fine feed handwheel.

Manufacturers state quill travel in millimeters, typically 50 to 130mm on bench and floor mill drills. You can read it on the depth scale fitted to the head, or with a dial indicator or a digital readout on the Z axis. Quill travel sets how far a tool can advance into the work without moving the head on the column.

Why it Matters for Band Saw and Mill Drill Machines

A long quill stroke helps drilling but costs rigidity. Each millimeter the quill extends below the head adds to the overhang, so a cutter running with the quill well down deflects more and chatters sooner. For milling, set the depth with the head or the table, keep the quill near the top of its travel and lock it.

A hole deeper than the stroke needs a second setup. You raise the table or lower the head and continue, and on a round-column machine the head can swing off the hole axis as it moves. A square column with dovetailed slideways, as on the RF-45 geared head mill drill, keeps the head on its axis when you move it.

Wear collects in the part of the stroke used most often. A worn rack and pinion gives a rough or uneven feel at the quill feed lever, and a worn bore lets the quill move sideways. Check side play with a dial indicator against the extended quill as part of routine inspection.

FAQ

How does quill travel affect drilling depth on a mill drill?

Quill travel sets the deepest hole you can drill in one plunge, but the usable depth is always less than the stated stroke. Part of the stroke goes on bringing the drill down to the work, so set the head so the drill point sits a few millimeters above the surface before you start. The point itself also uses depth. A standard 118° twist drill point extends about 0.3 times the drill diameter beyond the full-diameter part of the hole, so a 20mm drill needs about 6mm more travel than the full-diameter depth. Add that allowance when you compare a blind hole with the stroke.

Why does the quill on a mill drill not return fully to the top of its stroke?

The usual cause is weak tension in the coiled return spring behind the feed pinion. The spring loses tension with age, and you can restore it by releasing its cover and winding it one more turn. If the spring is sound, check that the quill lock is fully released and that chips or dried oil have not collected on the quill. A burr on the rack teeth can also stop the quill short.

How much quill travel should you look for when choosing a mill drill?

Choose a stroke that covers your deepest regular hole in a single plunge, with some margin for the approach and the drill point. If most of your work is drilling and tapping in plates and flanges, a stroke near the upper end of the usual range saves repeated head moves. If the machine will mainly mill, stroke matters less, because you set milling depth with the head and lock the quill. Read the quill travel together with the maximum distance from spindle nose to table. That distance, less the height of your vise and workpiece and the length of the tool in its chuck, shows whether a long drill will fit above the work at all. A long stroke gives no practical gain on a machine with little room between spindle and table.